These
specially shaped separators are used in rectangular
chutes or round pipes where flow speeds and
depths exceeds the capacity of plate magnets.
Humps are recommended if the flow is vertical,
or if the angle of the chutes is more than 70
degrees. The angular shapes of the housing conduct
the powder or granular material directly against
the plate magnets. The product stream shrikes
the first magnet. Then changes direction to
the hit the second magnet. Thus slows and against
the material, resulting in a better separation
than with convention chutes separation. If product
flow is light, on magnet in the half hump model
may provide sufficient separation. NOTE: Custom-made
humps to suit any special requirements can supplied.
|
